13
1
f
While holding the end of the thread, gently
press the foot controller to wind the thread
around the bobbin a few times. Then stop the
machine.
g
Trim the excess thread above the bobbin.
h
Press the foot controller to start.
i
When the bobbin seems full and begins
spinning slowly, take your foot off the foot
controller.
j
Cut the thread, slide the bobbin winder shaft
to the left and remove the bobbin.
Memo
● When the sewing machine is started or the
handwheel is turned after winding the
thread around the bobbin, the machine will
make a clicking sound; this is not a
malfunction.
● The needle bar does not move when you
slide the bobbin winding shaft to the right.
● Make sure you follow the instructions
carefully. If you do not cut the thread
completely, and the bobbin is wound, when
the thread runs low it may tangle around the
bobbin and cause the needle to break.
CAUTION
● Winding the bobbin improperly may cause
the thread tension to loosen, breaking the
needle and resulting in injury.
a Wound evenly
b Wound poorly
CAUTION
1
2
LS2125.book Page 13 Tuesday, February 26, 2008 1:43 PM
To Next Page
Loading...
