39
3
e
Turn the handwheel toward you
(counterclockwise) to check that the needle
correctly goes into the two holes of the
button.
If the needle hits the button, return to step
a.
f
Start sewing.
• After sewing for about 10 seconds at a low
speed, press and hold down the reverse
sewing lever to sew a few reinforcement
stitches.
g
Pull the fabric to the left side of the machine,
and then cut the upper and lower threads,
leaving a length of 15 cm (6 inches).
h
Pull the upper thread at the end of the
stitching to the wrong side of the fabric, and
then tie it with the bobbin thread.
Use scissors to cut the upper thread and the
bobbin thread at the beginning of the stitching.
● When sewing, be sure that the needle does
not touch the button, otherwise the needle
may bend or break.
CAUTION
LS2125.book Page 39 Tuesday, February 26, 2008 1:43 PM
To Next Page
Loading...
