EasyManuals Logo

Brother MFC-J6535DW Product Safety Guide

Brother MFC-J6535DW
20 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #15 background imageLoading...
Page #15 background image
15
Federal Communications Commission (FCC) Declaration of
Conformity (USA only) 1
declares, that the products
Product Name:
MFC-J5330DW/J5830DW/J5930DW/J6530DW/J6535DW/J6730DW/J6930DW/J6935DW
comply with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and (2) this device must accept any
interference received, including interference that may cause undesired operation.
This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This equipment generates, uses, and can
radiate radio frequency energy and, if not installed and used in accordance with the instructions,
may cause harmful interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by turning the equipment
off and on, the user is encouraged to try to correct the interference by one or more of the following
measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
Consult the dealer or an experienced radio/TV technician for help.
This transmitter must not be co-located or operated in conjunction with any other antenna or
transmitter.
IMPORTANT
Changes or modifications not expressly approved by Brother Industries, Ltd. could void the
user’s authority to operate the equipment.
A specific shielded interface cable should be used to ensure compliance with the limits for a
Class B digital device.
Responsible Party: Brother International Corporation
200 Crossing Boulevard
Bridgewater, NJ 08807-0911 USA
TEL: (908) 704-1700

Other manuals for Brother MFC-J6535DW

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Brother MFC-J6535DW and is the answer not in the manual?

Brother MFC-J6535DW Specifications

General IconGeneral
BrandBrother
ModelMFC-J6535DW
CategoryAll in One Printer
LanguageEnglish

Related product manuals