82
ERROR MESSAGE LIST
SET AV2067 TAPE!
●
This message appears if an
AV2067 Address label cassette
is not installed when printing an
AV2067 Address template of
the Auto Format function.
●
Install an AV2067 Address
label cassette.
SET STAMP-L!
●
This message appears if a 1"
(24-mm)-wide stamp tape cas-
sette is not installed when print-
ing an Auto format template
created for a STAMP L stamp.
●
Install an 1" (24-mm)-wide
stamp tape cassette.
SET STAMP-M!
●
This message appears if a 3/4"
(18-mm)-wide stamp tape cas-
sette is not installed when print-
ing an Auto format template
created for a STAMP M stamp.
●
Install an 3/4" (18-mm)-
wide stamp tape cassette.
TAPE END!
●
This message appears if the end
of the tape in the cassette has
been reached.
●
Replace tape cassette.
TEXT TOO HIGH!
●
This message appears if the size
of the text is larger than the
width of the installed tape.
●
(PT-9600 only) This message
appears if the Lines of Text set-
ting for the ESC/P interface
mode exceeds the maximum
possible for the installed tape.
●
Reduce the size of the
characters, install a tape
with a greater width or
select the AUTO text size
setting.
●
Specify the correct setting
for the installed tape.
TEXT TOO LONG!
●
This message appears if the
length of the text is longer than
the label length that has been
set with the Tape Length func-
tion.
●
This message appears if you try
to print a label that is longer
than the maximum label length.
●
This message appears if you try
to print a label that is longer
than the maximum label length
or is longer than the specified
block length.
●
This message appears if the
length of the text is longer than
the width of the tape when the
Text Rotation function is used.
●
Delete some of the text,
reduce the character
width, or increase the set
label length.
●
Delete some of the text or
reduce the character size.
ERROR MESSAGE CAUSE SOLUTION
To Next Page
Loading...
