Setting up the P-touch labeler
To setup the printer, please follow the steps below:
1. Setting the tape cassette
a. Open the cassette cover.
b. Insert the tape cassette.
c. Close the cassette cover.
If you cannot close the cassette cover, check to ensure the white lever is in the up position. If not, lift the lever, and then attach the cover.
Make sure that there is no slack in the tape.
When setting or removing the tape cassette, make sure that the tape does not catch on the protrusion (1) or the print head.
2. Connecting the power supply
Power the P-touch labeler using the AC adapter or batteries.
Using the AC adapter
Plug in the P-touch labeler using the AC adapter.
To Next Page
Loading...
