To Next PageTo Next Page
Need help?Do you have a question about the BRP Can-Am Spyder RS SM5 2011 and is the answer not in the manual?
General| Fuel Capacity | 6.6 gallons |
|---|---|
| Front Suspension | Double A-arm with anti-roll bar |
| Rear Suspension | Swing arm with monoshock |
| Front Tires | 165/65R14 |
| Rear Tire | 225/50R15 |
| Horsepower | 106 hp |
| Torque | 77 lb-ft |
| Transmission | 5-speed manual with reverse |
| Engine Type | Rotax 991 cc V-twin, liquid-cooled with electronic fuel injection and electronic throttle control |
Procedures for safely removing the vehicle from its shipping crate.
Steps for removing, charging, and installing the vehicle's battery.
Changing low beam headlights for left-hand traffic countries.
Recommending and verifying clutch fluid level for SM5 models.
Recommending and verifying engine coolant level.
Recommending specific engine oil and checking the level.
Detailed steps to verify engine oil level after running the engine.
Procedure for checking and adjusting the drive belt tension.
Detailed steps to adjust the front suspension spring preload based on load.
Detailed steps to adjust the rear suspension spring preload based on load.
Procedures for adjusting headlight aiming for different regions and models.
Using the B.U.D.S. software for vehicle programming and updates.
Procedures for properly ending a B.U.D.S. session and clearing faults.
Checklist for verifying proper assembly of vehicle components.
Performing a test ride to ensure all systems operate correctly.
Final steps for delivering the vehicle to the customer.
Detailed specifications for the front suspension components.
Detailed specifications for the rear suspension components.
Specifications for the braking system, fluid, and pads.
Specifications for tire type and pressure recommendations.
