To Next PageTo Next Page
Need help?Do you have a question about the BRP Can-Am Spyder RT 2013 Series and is the answer not in the manual?
General| Tires Front | 165/55R15 |
|---|---|
| Tire Rear | 225/50R15 |
| Engine Type | Rotax 998 cc V-Twin |
| Transmission | 5-speed manual with reverse |
| Fuel Capacity | 6.6 gal (25 l) |
| Seat Height | 30.4 in (772 mm) |
| Brakes | Hydraulic 3-wheel disc brakes with ABS |
| Length | 105 inches |
| Brakes Front | 270 mm discs with Brembo calipers |
| Brakes Rear | 270 mm disc with Brembo caliper |
| Wheelbase | 67.5 inches |
Steps for safely removing the protective crate cover from the vehicle.
Procedures for removing components and sub-crates from the vehicle packaging.
Instructions for cleaning front and rear brake discs before wheel installation.
Steps for mounting and torquing the front wheels onto the vehicle.
Steps to install plastic bushings on the rear shock absorber lower bracket.
Detailed steps for installing the front cargo module on the vehicle.
Procedures for correctly installing the vehicle battery, including charging.
Steps for installing various body panels such as fascia, side panels, and mirrors.
Instructions for installing the front fenders, including harness routing.
Steps for installing the windshield, including trim panels.
Procedure for installing the vehicle antenna on the rear cargo module.
Guidelines for installing licence plate, accessories, decals, and trailer key barrels.
General information on validating factory-filled fluids and referring to the shop manual.
Instructions for accessing the fuel reservoir and adding fuel.
Specifies the recommended engine oil type and alternatives based on API classification.
Detailed procedure for checking the engine oil level, including warm-up requirements.
Identifies the correct type of brake fluid for the clutch system.
Steps to check the clutch fluid level in the reservoir.
Specifies the type of coolant and antifreeze mixture for the cooling system.
Procedure for checking the engine coolant level, emphasizing cold checks.
Details the required DOT 4 brake fluid and warnings against contamination.
Steps to check the brake fluid level in both reservoirs.
General advice on factory adjustments and referring to the shop manual.
Instructions for checking and inflating tires to the correct cold pressure.
Procedure for measuring and verifying the drive belt tension using a specific tool.
Guide for adjusting the air pressure in the ACS rear suspension system.
How to adjust the distance between the clutch lever and the handgrip.
Procedure to verify the correct aiming of the vehicle's headlights.
Steps to verify proper latching of the front storage compartment cover.
Test procedure for the side storage compartment covers opening and latching.
Procedure to verify proper operation of the top storage compartment cover.
Guide to setting the hours and minutes on the vehicle's clock.
Instructions for choosing between 12-hour and 24-hour time display.
Steps to connect a PC to the vehicle for B.U.D.S. software operations.
Procedure to input the customer's name into the vehicle's system via B.U.D.S.
Instructions for resetting the 'Last Service' reminder using B.U.D.S.
Checklist of critical parts to inspect for proper assembly and torque specifications.
Procedure for performing a test ride to verify all vehicle systems are operating correctly.
Important warnings and advice for safely cleaning the vehicle without causing damage.
Steps for completing the pre-delivery checklist and handing over the vehicle to the customer.
Technical specifications for the Spyder RT model in North American markets.
Technical specifications for the Spyder RT (CE) model in European markets.
