36
Using Your Evinrude E-TEC Outboard
5) Hook the knot of the emergency start cord
into the notch on the flywheel that is oppo-
site the starter shaft.
Next, wind the cord clockwise in the groove
of the flywheel. Place the start cord be-
tween the notch of the flywheel and the
starter shaft.
6) Continue winding the cord clockwise in the
flywheel groove, making one and a half full
windings with the cord.
7) Turn key switch ON.
8) From a secure position in the boat, pull
hard on emergency starting cord to start
engine.
Repeat procedure, if necessary, until engine
starts.
9) Refasten flywheel guard in place by push-
ing the three fastening tabs back onto the
fittings.
If equipped, snap engine cut–out switch teth-
er cord to secure place on clothing. Proceed
immediately to nearest landing for service.
1. Notch
2. Starter shaft
3. Knot
008843
1. Cord in flywheel groove
008844
CAUTION
Keep everyone clear of your immediate
area when pulling on emergency starting
cord, especially behind you.
1. Fastening tabs
002023
DANGER
Contact with a rotating flywheel can
cause severe personal injury. Use
extreme care in re-fastening the flywheel
guard on the fastening tabs. Keep hands,
hair, and clothing away from coming in
direct contact with rotating parts.
To Next Page
Loading...
