EasyManua.ls Logo

BRP Evinrude E-TEC 60 - Scratch Repair; Spark Plugs; Submerged Outboard

BRP Evinrude E-TEC 60
98 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
61
Service
a deep, durable gloss with maximum ultravio-
let (sunlight) protection.
The high gloss finish will show polish marks
when viewed closely in certain light condi-
tions. This glossing is NORMAL.
Periodically, wash the entire boat and out-
board with soapy water and apply a coat of
automotive wax. Leave the engine cover in
place when washing the outboard.
Scratch Repair
Surface scratches on the upper and lower en-
gine covers can be polished out with buffing
compound.
Treat affected areas using these steps:
1) Sand the affected area with 800-grit sand-
paper.
2) Wet sand the area with 1200-grit sandpa-
per.
3) Using a composite material buffing com-
pound, polish the area, closely following
the product directions.
Spark Plugs
Spark plugs should be serviced by an Evin-
rude E-TEC Dealer. Incorrect spark plug
maintenance can lead to engine damage.
Marine Engine Duty Cycles
The International Council of Marine Industry
Associations (ICOMIA) Standard No. 36-88
specifies a marine engine duty cycle based on
documented studies. A duty cycle is a profile
of engine running and usage. This duty cycle
is used to determine average spark plug lon-
gevity and maintenance requirements for
Evinrude E-TEC outboards.
Submerged Outboard
If your outboard has been under water, have
it serviced immediately upon recovery. If
immediate service is unavailable, resub-
merge it in fresh water to avoid prolonged ex-
posure to the atmosphere.
After submersion, all boat and engine electri-
cal, fuel, and oiling systems must be inspect-
ed for signs of water intrusion. Your Dealer
should perform this service.
NOTICE
Your Dealer has the professional materi-
als to properly repair scratches. Do not
attempt to paint over marks or scratches
in the composite material. See your
Dealer to repair any deep scratches or
gouges.
CAUTION
The ignition system presents a serious
shock hazard. Use caution to avoid
injury from shock or injury resulting
from your reaction to shock. Do not han-
dle primary or secondary ignition com-
ponents while the engine is cranking or
running.
NOTICE
Replacement spark plugs MUST be
indexed correctly.
NOTICE
Some running profiles and conditions
can lead to spark plug wear sooner than
expected. Depending on your specific
usage, the spark plug maintenance
schedule may require adjustment.
ICOMIA Marine Engine Duty Cycle
Engine Speed as
Percentage of Rated
Speed (RPM)
Time at Specified RPM
(Percentage of total
engine running time)
IDLE 40%
40% 25%
60% 15%
80% 14%
100% 6%

Table of Contents

Related product manuals