36
Over-trimming increases engine RPM
while decreasing speed. The best trim
setting is when the highest speed is
achieved with the lowest engine RPM.
IIMMPPOORRTTAANNTT:: Weight distribution
can affect the performance of the
boat. Distribute weight evenly in the
boat.
TTrriimm AAnnggllee AAddjjuussttmmeenntt
Use the trim/tilt switch to adjust the
outboard position in the tilt range or
trim range.
1. Tilt Range
2. Trim Range
SShhaallllooww WWaatteerr
NNOOTTIICCEE
WWhheenn ooppeerraattiinngg aa ttiilltteedd oouuttbbooaarrdd,,
ddoo nnoott rruunn aabboovvee aa ffaasstt iiddllee ssppeeeedd..
KKeeeepp tthhee wwaatteerr iinnttaakkeess ssuubb--
mmeerrggeedd aatt aallll ttiimmee ttoo pprreevveenntt tthhee
eennggiinnee ffrroomm oovveerrhheeaattiinngg..
TTiipp
Throttling past idle with the engine
tilted will cause the engine to auto-
matically trim down into the water to
help protect the engine.
Adjust the outboard position within the
tilt range for shallow water operation.
1. Water intakes
TTiilltt
The tilt range allows the operator to tilt
the outboard for clearance when
beaching, mooring, launching, or
trailering.
TTiilltt LLiimmiitt
See
ADJUSTMENTS
, if your outboard
contacts the boat’s motor well while
tilting.
TTiilltt SSuuppppoorrtt LLeevveerr
If you intend to leave the outboard
tilted for a period of time, engage the
tilt support lever.
1. Tilt the outboard UP using the trim/
tilt switch.
2. Flip the tilt support lever down.
Lower the outboard until the sup-
port lever rests solidly on the stern
brackets.
OPERATION
To Next Page
Loading...
