BRP Evinrude E-TEC G2 - Specifications Table

62
SSppeecciiffiiccaattiioonnss TTaabbllee
SSppeeccffiiccaattiioonnss IInnlliinnee 33––CCyylliinnddeerr 11..886655LL 111155 HH..OO..,, 114400 HHPP,, 115500 HHPP
Displacement
113.865 cu.in. (1865cc)
Engine Type
Inline 3–Cylinder, Two-Cycle, E-TEC
Full Throttle
Operating Range
(1)
111155 HHPP HH..OO..–– 5000 to 6000 RPM
114400 HHPP–– 5000 to 6000 RPM
115500 HHPP––5000 to 6000 RPM
Power
(1)
111155 HHPP HH..OO..–– (84.60 kw) @ 5500 RPM
114400 HHPP –– (100.80 kw) @ 5500 RPM
115500 HHPP –– (110.32 kw) @ 5500 RPM
Idle RPM in
Neutral
(2)
500± 50
Idle RPM in
Gear
(2)
600± 50
Ignition Timing
(2)
Controlled by the outboard’s EMM
Emission Control
System: per SAE
J1930
(2)
EMM, E-TEC (Engine Control Module, E-TEC )
Fuel
Requirements
(2)
AKI (R+M)/2 — 87 Octane
Oil
Lubricant
Evinrude XD
†
oils or a synthetic TC-
W3 NMMA-certified oil
– 1.88 Gallons (7.12 liters)
† Evinrude XD oils exceed the specifications of NMMA
TC-W3 certification
Capacity
Warning Signals Controlled by the outboard’s
EMM
Battery,
Minimum
(3)
675 CCA (845 MCA) 12 volt or
750 CCA (940 MCA) 12 volt below 32°F (0°C)
Spark Plug
(2)
Type
CHAMPION QQCC88WWEEPPIIAA
Gap 0.028 in. (0.71 mm)
Fuses
Mini-fuse:
3A- 3011805
5A- 504764
10A- 514766
30A- 3011729
Fuel Filters
Inline P/N 360941
Water
Separating
P/N 5009902