BRP ROTAX 912 Series Service Bulletin

d06856.fm
SB-912-074 / SB-914-056
SERVICE BULLETIN
03 December 2020 73-00-00
Initial Issue Page 3 of 12
Copyright - BRP-Rotax GmbH & Co KG. All rights reserved.
1.4) Subject
Exchange of floats (pair) on ROTAX
®
Engine Type 912 and 914 (Series).
1.5) Compliance
- At rough engine running, especially at low engine speeds (crankshaft speed to 4000 rpm), or
fuel leakage carry out this exchange before the next flight
- Carry out this exchange of the floats on the engines listed in section 1.1., according to the
instructions in section 3 at the next ROTAX
®
scheduled maintenance event, but at the latest
after 1year (from the date of the initial issue of this Service Bulletin)
- On undelivered engines/spare parts prior to delivery
- Before the initial installation of engine and/or spare part
1.6) Approval
The technical content of this document is approved under the authority of the DOA ref.
EASA.21J.048.
1.7) Labor time
A labor credit will be provided for work performed by a technician with current applicable iRMT rat-
ing.
* in this case no labor will be covered for engine test run as this work is anyhow performed in
course of a standard maintenance event.
To apply for labor credit, contact your ROTAX
®
Authorized Distributor or their independent Ser-
vice Centers.
1.8) Mass data
Change of weight - - - none.
Moment of inertia - - - unaffected.
1.9) Electrical load data
No change.
1.10) Software modifications
No change.
m
WARNUNG
m
WARNING
Non-compliance with these instructions could result in engine damag-
es, personal injuries or death.
Work performed
iRMT rating
required
Labor
credit
Disassembly, replacement of parts, re-
assembly, test run and logbook entry as
per Chapter 3 (per engine)
iRMT Maintenance Line 0.25 h* (912 Series,
2-stroke Series)
0.5 h* (914 Series)

BRP ROTAX 912 Series Specifications

General

Brand	BRP
Model	ROTAX 912 Series
Category	Engine
Language	English