BRP ROTAX 916 i A Series Maintenance Manual

BRP-Rotax
MAINTENANCE MANUAL LINE
Independent of subsequent following inspections are required:
Non compliance with fuel quality
Step
Procedure
1
Visual inspection of engine.
2
Empty the fuel system according to the instructions of aircraft manufacturer.
3 Flush fuel system.
4
Check cylinder differential pressure.
5 Engine test run.
SMOOTH PERFORMANCE OF THE ENGINE
General note
m WARNING
Risk of electric shock!
Ignition “OFF” and system grounded! Disconnect negative terminal of battery.
Inspection Inspection of smooth performance of the engine should be performed at a temperature
about 0 °C to 60 °C (32 °F to 140 °F).
Engine runs sluggishly
Step
Procedure
1
Remove spark plug connector and remove 1 spark plug from each cylinder.
2 Torque must be determined with a suitable jig.
To do this, determine the maximum occurring torque on the propeller shaft
necessary to move the whole crank drive.
The torque must be max. 150 Nm (111 ft.lb).
If the maximum torque is exceeded, perform the following inspections:
• Carry out detailed inspection of the affected gearbox components
• Carry out detailed inspection of crank drive
05–50–00
Page 40
December 01 2023
Effectivity: 916 i A / C24
Edition 0/Rev. 1

BRP ROTAX 916 i A Series Specifications

General

Brand	BRP
Model	ROTAX 916 i A Series
Category	Engine
Language	English