BRP ROTAX 916 i A Series Maintenance Manual

BRP-Rotax
MAINTENANCE MANUAL LINE
Step
Procedure
8
Shut engine down.
NOTE
Switch “OFF” lanes, fuel pumps and master switch.
9 Inspect rotary seal leakage bore.
NOTE
Due to the design of the rotary seal, the manufacturer tolerates a
certain amount of leakage. If the leakage is in excess of the limit ro-
tary seal must be renewed.
Tolerated leakage:
For this check the engine must be operated until all temperatures have sta-
bilized for a period of 5 minutes. At that point shut down engine and ensure
the ignition is switched “OFF” and engine secured against unintentional op-
eration. Coolant must not drip through leakage bore, located at the base of
the ignition housing, for a period of 1 minute after the engine has been
stopped. In case this leakage test can not be passed, the rotary seal must
be renewed.
Engine oil and
coolant
m WARNING
Risk of Burns!
Never open the radiator cap when the cooling system is hot. For safety’s sake, cover
cap with a rag and open slowly. Sudden opening of the cap could provoke the escape
of boiling coolant and result in scalding.
Replenish engine oil and coolant as required once engine has cooled down.
Oil filter
NOTICE
If the oil filter has been replaced, re-tighten by hand after the test run on a cold
engine.
Check of leaks Inspect the engine for oil, fuel or coolant leaks and repair as necessary.
12–20–00
Page 18
December 01 2023
Effectivity: 916 i A / C24
Edition 0/Rev. 1

BRP ROTAX 916 i A Series Specifications

General

Brand	BRP
Model	ROTAX 916 i A Series
Category	Engine
Language	English