BRP ROTAX 916 i A Series Maintenance Manual

BRP-Rotax
MAINTENANCE MANUAL LINE
DRIVE GEAR – REMOVAL
NOTICE
The large and small gears are considered the same part (with the same part num-
ber and same serial number). They must not be mixed up with other gear sets.
Step
Procedure
1 Lock the crankshaft into place. See Chapter 12–20–00.
2
Heat the hex. nut M30x1.5 with the hot air gun (100–120 °C
(212–248 °F)).
3 Turn clockwise (left hand threads) to loosen hex. nut M30x1.5 with sock-
et wrench SW 41 part no. 877445.
Figure 5.4
1
Socket wrench SW 41 part no. 877445
2 Hex. nut M30x1.5
Step
Procedure
4
Remove the drive gear and the friction washer from the crankshaft.
NOTE
If necessary, carefully lever off the drive gear with 2 screwdrivers.
NOTE
The gear set (large and small drive gear) are part of the gearbox assy. and both
must be included if sending gearbox out for inspection or overhaul.
05–50–00
Page 6
December 01 2023
Effectivity: 916 i A / C24
Edition 0/Rev. 1

BRP ROTAX 916 i A Series Specifications

General

Brand	BRP
Model	ROTAX 916 i A Series
Category	Engine
Language	English