Brush Bandit 2000XP - Hydraulic Section; Hydraulic Fluid Requirements

Bandit
Copyright 5/09 PAGE 50
MODELS 2000XP / 2100SP
HYDRAULIC SECTION
DO NOT GO NEAR HYDRAULIC LEAKS!
High pressure oil easily punctures skin causing serious injury, gangrene, or death.
If injured, seek emergency medical help. Immediate surgery is required to remove
oil. DO NOT use ngers or skin to check for leaks. Lower load or relieve hydraulic
pressure before loosening ttings.
HYDRAULIC FLUID REQUIREMENTS
Hydrex XV
>235
>240°C /464°F
>9,000 Hours
-40°C/-40°F
ISO 22, AW
>95
>200°C /395°F
>3,000 Hours
-34°C/-29°F
ISO 32, AW
>95
>210°C /410°F
>3,000 Hours
-26°C/-14°F
ISO 46, AW
>95
>220°C /430°F
>3,000 Hours
-19°C/-3°F
ISO 68, AW
>95
>220°C /430°F
>3,000 Hours
-9°C/16°F
ISO 100, AW
>95
>240°C /464°F
>3,000 Hours
-4°C/24°F
Viscosity Index
Flash Point
Oxidations
Stability
(ASTM D0943)
Cold Start-up,
No Load, Max
HYDRAULIC SECTION
WARNING
DO NOT operate this machine unless all hydraulic control devices operate properly. They must function, shift
and position smoothly and accurately at all times. Faulty controls can cause personal injury!
WARNING
This machine is equipped with “Petro-Canada Hydrex XV” hydraulic uid. It is recommended to replace with
the same. “Petro-Canada Hydrex XV” is an all season hydraulic uid. This is a premium performance, long life
anti-wear, hydraulic uid, designed for all season use in heavy duty hydraulic systems. “Petro-Canada Hydrex XV”
allows year round use under wide extremes of temperature. It allows the hydraulic system to start at temperatures
as low as -40°C/-40°F, under no load conditions and it improves lubrication of hydraulic components at high
operating temperatures. It will also help protect against hydraulic failures during the wide temperature swings
of spring and fall. To nd the closest “Petro-Canada Hydrex XV” dealer call 1-888-284-4572.
Multi Viscosity motor oils are not recommended to mix with “Petro-Canada Hydrex XV” hydraulic oil. AW oils
may mix with “Petro-Canada Hydrex XV” hydraulic oil. The following are specications and authorizations of
compatible oils. Only a high quality anti-wear (AW) hydraulic oil containing foam, corrosion, rust and oxidation
inhibitors should be used. This viscosity grade depends on the oil temperature in service, based on the climate
and operating conditions.