GENERAL MAINTENANCE
1. Oil should not be used on the 10552 Brutus Tile Cutter. Use of oil will cause
eventual gumming and sticking of the movable parts as the oil combines with
dirt and ceramic tile dust.
2. Wear is normal in the chrome plated rails and can be evenly distributed by
occasional rotation of each of the two rails. For cutters with hex bolts holding
the rails, loosen each hex bolt and slightly rotate the rails. Retighten the hex
bolts when finished.
3. The only part routinely needing replacement is the carbide scoring wheel.
All other parts are also available.
- 3 -
EXTRA CUTTING WHEEL
STORAGE
The 20 in. Brutus Tile Cutter features a
convenient storage compartment in the
handle, for spare 7/8 in. cutting wheels (Fig
6). Simply unscrew the handle end to open.
1 support
2 sponge cushion 2
3 sponge cushion 1
4 sliding bar
5 flat washer
6 guide knob
7 ruler
8 buffer circle
9 flat washer
10 spring washer
11 bolt
12 nut
13 bearing cover
14 bearing
15 nut
16 slide
17 bolt
18 connecter
19 bolt
20 cutting wheel
21 nut
22 bolt
23 breaker foot
24 push bar
25 handle base
26 flange nut
27 handle cover
28 angle guide lever
29 flat washer
30 adjustable angle guide
31 nut
32 base
PARTS LIST
FIG. 6
CUTTING
WHEEL STORAGE
10552_manual 9/4/08 1:59 PM Page 3
To Next Page
Loading...
