To Next PageTo Next Page
Need help?Do you have a question about the Bryant LEGACY T2-PAC and is the answer not in the manual?
General| Display | Backlit LCD |
|---|---|
| Wi-Fi Capable | No |
| Remote Access | No |
| Humidity Control | No |
| Energy Usage Reports | No |
| Alerts | No |
| Voice Control | No |
| Power Source | Battery |
| Programmability | Non-programmable |
| Compatibility | Gas, Oil, Electric |
Explains safety alert symbol, DANGER, WARNING, CAUTION, and NOTE, highlighting potential hazards and precautions.
Recommends optimal placement for the thermostat, considering room usage, wall type, and airflow.
Covers powering off, removing old thermostats, separating the base, and mounting the base to the wall.
Details routing wires, stripping insulation, connecting to terminal blocks, and handling separate transformers.
Instructions on how to properly connect the thermostat housing to the installed backplate.
Lists and briefly explains various available configuration settings for the thermostat, including installer-only options.
Explains the process of accessing and navigating the thermostat's configuration settings using specific button presses.
Sets the thermostat to control specific HVAC equipment types like HP, H2, AC, A2, H, or C.
Explains the built-in installer test mode to verify thermostat and equipment functionality without delays.
Lists common error codes (e.g., -- for sensor failure, E4 for memory failure) and their remedies.
Illustrates the typical wiring connections for a single-speed Air Conditioner system.
Shows the typical wiring connections for a single-speed Heat Pump system.
