Need help?Do you have a question about the Bryston BDA-3 and is the answer not in the manual?
General| Weight | 12 lbs |
|---|---|
| Jitter | Below measurable levels |
| Signal to Noise Ratio | >120dB |
| Digital Inputs | 2 x AES/EBU |
| Analog Outputs | XLR, RCA |
| Supported Formats | PCM, DSD |
| HDMI Audio | Yes |
| Control | RS-232, IR |
| Dimensions | 17 x 2.75 x 11.25 inches |
| Frequency Response | 20 Hz to 20 kHz ±0.1dB |
| Output Impedance | 100 ohms |
| Digital to Analog Converter | AKM 4490 |
| Output Level | 4V RMS (XLR), 2V RMS (RCA) |
Explains how to connect various digital source components to the BDA-3.
Instructions for connecting the BDA-3's analog outputs to a preamplifier.
Controls for power status and selecting the digital audio input source.
Describes the AC power input and the analog audio output connections.
Details the various digital audio inputs, including S/PDIF, Toslink, and USB.
To Next Page
