8 Mounting
Mounting position limitations and carrier board recommendations
Please refer to BSH confidential documents “eP_SMM_S2_Module_Datasheet” (TC No.
60100005053441) and „HW Reference Manual“ (TC No. 60100005053429).
The module is designed to be used in a mobile device which will be used in such a way
that a separation distance of at least 20cm is.
Appliances only for indoor use.
Module will be integrated only by BSH and companies commissioned by BSH into
appliances.
Changes or modifications not expressly approved by the party responsible for compliance
could void the user’s authority to operate the equipment.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following
two conditions:
(1) This device may not cause interference.
(2) This device must accept any interference, including interference that may cause
undesired operation of the device.
This device contains licence-exempt transmitter(s)/receiver(s) that comply with Innovation,
Science and Economic Development Canada’s licence-exempt RSS(s). Operation is
subject to the following two conditions:
(1) This device may not cause interference
(2) This device must accept any interference, including interference that may cause
undesired operation of the device..
Cet appareil contient des émetteurs / récepteurs exemptés de licence conformes aux
RSS (RSS) d'Innovation, Sciences et Développement économique Canada. Le
fonctionnement est soumis aux deux conditions suivantes:(1) Cet appareil ne doit pas
causer d'interférences(2) Cet appareil doit accepter toutes les interférences, y compris
celles susceptibles de provoquer un fonctionnement indésirable de l'appareil.
When integrating the module into an appliance the integrator has to ensure that the
appliance will comply with FCC/ISED requirements!
To Next Page
Loading...