Verve 500 – New Style – Edition 3 – 07.09.06 – 7706
If you experience any problems, please call the Helpline on 0870 242 6652 or email bthelpdesk@convergys.com
Using the phone
15
Switch the handset power on/off
1. From standby mode, press and hold to switch off. You will
hear a long beep and the display will go blank.
Or
Press and hold
to switch back the handset on. You will
hear a long beep and the standby display will be shown.
Make an external call
1. Press .
2. When you hear the dialling tone, dial the number you want.
Preparatory dialling (pre-dial)
1. Enter the number you want to dial first.
2. Press to dial.
End a call
1. Press .
Or
Place the handset back on the base (if auto answer is set
to on).
When you make a call,
Calling
and
the icon are displayed and the red
In Use light on the base comes on,
Call timer
Your handset will automatically time
the duration of all external calls. The
handset display shows the call
duration both during and for a few
seconds after your call.
The symbol on the display
indicat
es when you are in r
ange of the
base. If the symbol flashes and
you hear a warning beep during a
call, you are out of range and will
need to move closer to the base.
Pr
ess the soft key to delete an
incorrect digit.
The pre-dial number can be up to 24
digits long.
To Next Page
Loading...
