12 Connect other computers and devices
An even easier way to connect devices
Your clever new Hub has a WPS (wi-fi protected set-up) button. This means all
you need to do to connect a WPS-enabled device or PC (running Windows 7 or
Windows Vista with Service Pack 2) is:
• use the device or PC you’re trying to connect to broadband
• find and select your Hub’s network name
• click Automatically connect
• press the WPS button on your Hub within two minutes
To find out more about WPS, go to www.wi-fi.org/wifi-protected-setup
You may need these details:
Authentication type: WPA2-PSK or WPA-PSK
Encryption type: AES (WPA2) or TKIP (WPA)
Mode: infrastructure (not ad hoc)
To Next Page
Loading...
