Reset to factory settings
If you need to access advanced settings, have forgotten your password or if the extender
stops working you can reset it to its factory settings.
1 Make sure the extender is plugged in and switched on.
2 Press the Reset button for 1 second to restore factory default settings.
Using the ethernet cable
You can connect an additional device to the ethernet port that will use the wi-fi extension
at the same time as your wireless devices.
Connect your device to the extender’s ethernet port using an ethernet cable.
General information
For information on safety instructions,
technical information or setting
up the extender, please see the
Frequently Asked Questions at
bt.com/wifiextender600
Guarantee
Your Dual-Band Wi-Fi Extender 600 is guaranteed for
a period of 3 years from the date of purchase. Subject
to the terms listed below, the guarantee will provide
for the repair of, or at BT’s or its agent’s discretion, the
option to replace the Dual-Band Wi-Fi Extender 600 or
any component thereof which is identified as faulty or
below standard, or as a result of inferior workmanship or
materials. Products over 28 days old from the date
of purchase may be replaced with a refurbished or
repaired product.
The conditions of this guarantee are:
• the guarantee shall only apply to defects that
occur within the 3 year guarantee period
• proof of purchase is required
• the equipment is returned to BT or its agent
as instructed.
This guarantee does not cover any faults or defects
caused by accidents, misuse, fair wear and tear, neglect,
tampering with the equipment, or any attempt at
adjustment or repair other than through approved agents.
This guarantee does not affect your statutory rights.
To find out what to do if your extender is in or
outside of the 3 year guarantee, please see the FAQ
at bt.com/wifiextender600
How to recycle your equipment
The symbol shown here and on the product
means that the product is classed as electrical
or electronic equipment, so DO NOT put it in your
normal rubbish bin.
It’s all part of the Waste Electrical and Electronic Equipment
(WEEE) Directive to recycle products in the best way – to be
kinder to the planet, get rid of dangerous things more safely
and bury less rubbish in the ground.
You should contact your retailer or supplier for advice
on how to dispose of this product in an environmentally
friendly way.
R&TTE Directive & Declaration of Conformity
This equipment complies with the essential requirements
for the Radio Equipment and Telecommunications Terminal
Equipment Directive (1999/5/EC).
For a copy of the Declaration of Conformity
please refer to bt.com/wifiextender600
This product uses open source codes available
from bt.com/help/gplcode
Power consumption
In operation 5.8 Watts
Network standby 2.7 Watts
Off mode 0.1 Watts
Elapsed time before going
into standby mode
5 Minutes
To Next Page
Loading...
