21
Freeway [A6] ~ Issue 1 ~ Edition 5 ~ 31st March ’03 – 5023
To switch the channel monitor ON or OFF
When you are not receiving a call your
handset automatically mutes the speaker
so that you will not hear weak signals or
background noise. You can switch this
feature off temporarily or for longer
periods of time. By switching channel
monitor ON you can hear transmissions
on your selected channel that you would
not hear under normal circumstances as
the signal is too weak.
To switch the handset display light
ON or OFF
Press the LIGHT button. The display will
light up for approximately 10 seconds.
Each time you press the VOLUME + or -,
CHANNEL + or -, CALL, MODE or LOCK
buttons while the display light is switched
on, the 10 second timer will reset so that it
will stay on for a further 10 seconds.
To switch the display light OFF, press the
LIGHT button.
To Next Page
Loading...