BT Home Monitor ~ 8th Edition ~ 26th March ’03 ~ 5296
Add / Delete Keypad
ADDING AND NUMBERING A KEYPAD
At the Control Panel, follow these instructions:
PRESS DISPLAY
Until the display shows
SYSTEM PROFILE.
Enter your MASTER CODE –
if you have not selected a
personal PIN number, this will
be the default setting – 2580.
Until the display shows
ADD / DEL KEYPAD.
Display shows 1-WAY KP NO:-
Enter the Keypad number you
want. e.g. 1 or press NEXT to
find the next available Keypad
location.
Display shows ACTIVATE NOW.
Press the ✱ button (next to 0) on
the Keypad for two seconds. You
will hear a confirmation melody.
Display shows
KEYPAD NO: (number) plus a black
box to signify that the slot is taken.
The Keypad is now registered.
Choose either:
To move to the next Keypad.
Or
Three times then <OK> to exit
to return to READY.
DELETING A KEYPAD
You may at some point decide you do not wish
to use one or more of the Keypads. To delete a
Keypad from the Control Panel, follow these
instructions:
PRESS DISPLAY
Until the display shows
SYSTEM PROFILE.
Enter your MASTER CODE –
if you have not selected a
personal PIN number, this will
be the default setting – 2580.
Until the display shows
ADD / DEL KEYPAD.
Display shows KEYPAD NO:-
Enter the Keypad number you wish
to delete e.g. 1 or press NEXT to
scroll through the list.
Display shows <OFF> TO DELETE.
Display shows
KEYPAD NO: (number).
Choose either:
To move to the next Keypad.
Or
Three times then <OK> to exit
to return to READY.
You may also wish to remove the battery.
NEXT
SHOW / OK
NEXT
SHOW / OK
SHOW / OK
NEXT
To Next Page
Loading...