power socket if you’re going to use for longer than this or throughout the night.
When the battery gets very low, it’ll take about 30 minutes to charge enough for you to use it for a short time.
To charge the Parent unit in the shortest amount of time, turn it off while it’s charging.
3. Place the Baby unit near a power socket in the room where you’re going to be monitoring your baby most of the
time. It should also be at least one metre away from your baby.
4. Plug the cable into the Baby unit, then plug it into the mains power socket and switch the socket on.
5. Slide the Off On button on the side of the Baby unit up to turn it on.
Tip
Keep the power cord out of baby’s reach by looping any extra length and securing it.
6. After the Parent unit has charged for 12 hours you can switch it on.
Before you do, move the Parent unit at least one metre from the Baby unit. Any closer and you might get audio
feedback sounds.
Press the button and hold for 2 seconds to turn the Parent unit on.
The Parent and Baby unit are automatically linked so they are now ready to use.
What’s the range?
The maximum range between your Parent and Baby units is about 250 metres outdoors and about 50 metres
indoors. Thick walls and doors reduce the units’ range and affect how they link to each other.
Troubleshooting
My Parent/Baby unit isn’t working. What should I do?
Check that:
To Next Page
Loading...
