BT Vision - User Manual

What’s in the box
Powerline adapters x2, ethernet cable, Quick Start guide
Connecting your Powerlines
If your BT Home Hub is in another room or is more than two
metres away from your Vision+ box you’ll need to use your
Powerline adapters
1
Using the Ethernet cable (yellow ends), connect one end to
your Hub’s Ethernet port 1
2
Connect the other end to a Powerline adapter
3 Then plug the Powerline adapter directly into a power
socket and turn it on
4
Using the Ethernet cable provided with your Vision+ box,
connect one end to the LAN socket at the back of your
Vision+ box
5
Connect the other end to a Powerline adapter
6 Then plug the Powerline adapter directly into a power
socket and turn it on. When you’ve plugged in both your
Powerline adapters, their Data lights should glow green
Note: your Powerline adapters will work with any version
of the BT Home Hub and Vision+ box, not just the ones
shown in the diagram
1
3
2
5
4
6
BT Vision Powerline Adapters
Data
Ethernet
Power
IMPORTANT: to work properly Powerline
adapters must be plugged directly into the
wall socket and not into extension leads
LED status description
Green
Orange
Red
Flashing
Off
Powerline network is detected with high transfer speed
Powerline network is detected with medium transfer speed
Powerline network is detected with low transfer speed
Any of the above flashing – a data transfer in progress
No Powerline connection
Green steady
Green flashing
Ethernet connection is detected
Ethernet traffic is detected
Green steady
Green flashing
Off
Power is on
The unit is in pairing mode, see overleaf
The mains power is off or the unit is in sleep mode.
The unit automatically wakes up from sleep mode when the
device connected to the Ethernet cable is powered up.

Summary

Whats in the box

Connecting your Powerlines

Compatibility Note

Powerline adapters work with any version of the BT Home Hub and Vision+ box.

Important: Wall Socket Connection

Powerline adapters must be plugged directly into the wall socket and not into extension leads.

LED Status Description

How to connect additional Powerline adapters to your network

Connection Tip

Plug your new Powerline and an existing one into the same double power socket for easier connection.

Reset to factory settings

Reset Procedure

Press the Reset button with a pointed object for 2 seconds. Lights will go out and the adapter will reset.

Need more help

Declaration of conformance

Product disposal instructions

BT Vision Specifications

General

Parental Controls	Yes
Connectivity	Ethernet
Video Output	HDMI, SCART
Audio Output	RCA
Tuner	Freeview
Wi-Fi	No
Recording	Yes
Hard Drive	40GB / 160GB (depending on model)
On Demand Services	BT Vision (BT TV)