VISIT!BAOFENGTECH.COM!AND!MIKLOR.COM!FOR!DOWNLOADS!AND!HELP!
Chapter!4.!–!Programm ing!
Frequency Mode vs. Channel Mode
Switch%between%Modes%by%Using%the%V/M%Front%Panel%Button%
These%two%modes%have%different%functions%and%are%often%confused.%
Frequency!Mode!(VFO)!-!Used!for!a!temporary!frequency!assignment,!such!as!a!test!frequency!or!
quick!field!programming!if!permitted.!!
Channel!Mode!(MR)!-!Used!for!selecting!preprogrammed!channels.!!
ALL!PROG RAMMING!MUST!BE!INITIALLY!DONE!IN!THE!FREQUENCY!MODE!(VFO)!ONLY.!FROM!THERE!YOU!
HAVE!THE!OPTION!OF!ASSIGNING!THE!ENTERED!DATA!TO!A!SPECIFIC!CHANNEL!FOR!ACCESS!IN!THE!CHANNEL!
MODE.!ONCE!YOU!PROGRAM!A!CHANNEL!YOU!CANNOT!CHANGE!THE!SETTINGS,!BUT!YOU!CAN!
PROGRAMM ING!CHANNELS!ARE!DIFFERENT!FROM!THE!VFO!SET TINGS;!THE!OFFSET!SETTING S!ARE!NOT!
STORED,!IN STEAD!YO U!ENTER!A!TX!FREQUENCY!DIRECTLY!(E.G.!145.000! RX!WITH!AN!OFFSET!OF!(+)!.600 !
WOULD!BE!A!TX!FREQUENCY!OF!145.600).!
To Next Page
Loading...
