BTECH UV-25X2 - Scanning for DCS Tone; DCS Tone Scanning Procedure

VISIT!BAOFENGTECH.COM!AND!MIKLOR.COM!FOR!DOWNLOADS!AND!HELP!
45!
!
!
!
!!Scanning!for!a!DCS!tone!
(ACTIVE%SIGNAL%REQUIRED)%
1. Press!the! !key!to!enter!the!menu.!
2. Enter! on!your!numeric!keypad!to!come!to!Menu!10:!R-DCS!
3. Press!the! !key!to!select.!
4. Press!the! !to!begin!DCS!sc ann ing !
A!flashing!"DCS"!will!be!in!the!left!status!display!to!indicate!the!radio!is!in!DCS!scanning!mode.!In!
this!mode ,!wh en eve r!the!ra dio!is!rece iving!an !RF !signa l!on!the !selecte d!MR!chan ne l!or!VF O!
freque ncy ,!the!low e r!disp lay!w ill!cycle!th rou gh!th e!D CS !cod es!a s!they !are!b eing !tested .!On ce !the!
bits!of!the!received!DCS!code!are!determined,!the!"DCS"!indicator!will!stop!flashing.!!
!
Press!the! !key!to!save!the!scanned!tone!into!memory!(VFO!M ode!On ly)!then!press!the! !key!
to!exit!the!men u .!
!
Don't%forget%to%set%VFO%menu%10%back%to%OFF%when%the%DCS%tone%is%no%longer%required.%
!! !