Heating function
If the measured temperature is lower than the reference value, the heating
system is active and the
symbol appears.
Cooling function
If the temperature measured is higher than the reference value, the cooling
system is active and the
symbol appears.
Automatic switching function (no icon)
If the temperature exceeds certain thresholds, the heating or the cooling
symbols can be displayed.
( * )
Temporary manual mode (only MyHOME with central unit)
This functions gives the possibility of temporarily switching from a set-point
sent by the central unit to a custom one. The mode remains active until a
new set-point is sent by the central unit.
( * )
Comfort mode
The system operates at the ideal set-point set in the heating and cooling
functions.
( * )
Eco mode
The system operates at the energy saving set-point set in the heating and
cooling functions.
( * )
Antifreeze / Thermal protection / Off
Antifreeze: minimum safety temperature.
Thermal protection: maximum safety temperature.
Off: zone off.
Automatic Mode ( * )
The remote setting (control unit or supervision software) follows.
In the case of MyHome systems, the icons shown with asterisks do not appear
on the display when the corresponding modes are set remotely.
2.2 Summary of functions and operating modes
2 Description
NOTE:
temporary display and/or deactivation
Example: when windows are opened in the controlled zone, system operation is modified or
suspended.
NOTE: some functions, such as switching the heating/cooling, setting the comfort, eco and
antifreeze/heat protection modes and automatic adjustment of the fan-coil fan may have been
disabled by your installer when configuring.
To Next Page
Loading...
Need help?
General
