Bticino Sfera Keypad Module Installer Manual

18
If the procedure has been successful the
green LED stays on for approximately 1
second before switching off.
A short beep and the LEDs switching off indicate that the programming procedure has been ter-
minated. The Sfera Keypad Module is now ready for normal operation.
During programming, some rules must be followed:
- keys must be pressed consecutively (maximum 2 seconds between pressures);
- the programming sequence must be started within 30 seconds from the moment the
programming pushbutton has been pressed and must be completed in one stage.
3 Configuration

Bticino Sfera Keypad Module Specifications

General

Brand	Bticino
Model	Sfera Keypad Module
Category	Control Unit
Language	English