14
Sfera Keypad Module
User and installation manual
Device configuration
It is possible to program three different types of codes:
ADMINISTRATOR Code granting access to the programming of the other codes.
This code has programming rights, but not access rights..
PASSEPARTOUT This code allows the opening of the door lock to which the entrance panel is
associated.
It is not connected with any apartments.
This code has access rights, but no programming rights.
RESIDENTS This code allows the opening of the door lock to which the entrance panel is
associated.
It’s linked to an apartment of the system.
This code has access rights, but no programming rights.
Ha solo diritto di accesso e non di programmazione.
The configuration can be performed in two ways:
- using thel TiSferaDesign software
- following specific procedures using the keypad
For the configuration of the administrator codes, remove the front cover and press the
programming button highlighted in the legend.
1 2
Administrator code
The “ADMINISTRATOR” code is required for safety reasons, and is directly programmed by the
installer. The code grants access to the programming of the other codes (passepartout and
residents).
In order to access programming mode, it will be necessary to assign an administrator code to the
device. It is possible to save up to 20 administrator codes.
The keypad module will indicate if the code is accepted or rejected through audible signals and
the switching on of the green LED. Entering an unrecognised code will cause the interruption of
the programming procedure. This interruption will be notified with an extended beep and the
switching on of the red LED.
Note : only with Sfera Speaker Module 351100/351200/351300 + the associated Sfera Pushbutton
Modules 352000/352100 or only with the Sfera Keypad Module.
New administrator code
1. Press and hold down the programming pushbutton until the green LED starts flashing and a
confirmation tone is heard..
2. Press the
key
To Next Page
Loading...
Need help?
General
