Page 52
SECTION VII
OPERATION
This section of the manual is to help you get the maximum efficiency and maximum smoke
(particulate) reduction from your heater. If you should experience any difficulty or have any
questions concerning your heater, contact your dealer for assistance. NOTE: The
manufacturer recommends that for maximum performance burn natural seasoned hard wood.
Build a fire for maximum efficiency. These models burn wood and extract heat so efficiently,
a large fire is not necessary. A large fire not only wastes energy, it usually results in the home
being too warm for comfort.
The following steps will serve as a guide for operating your stove.
BUILDING A FIRE
1. Open the door.
2. Open the primary air control under hearth, push in. To close pull all the way out.
3. Twist two pieces of non-colored newspaper into a roll and place them on the floor of the
firebox.
NOTE: Do not use grate or elevate fire. Build wood fire directly on inner bottom of fire box.
4. These models are not designed for the use of grates, andirons or other methods of
supporting the fuel.
5. Lay several pieces of dry kindling on top of the newspaper.
6. Place three or four small pieces of firewood, 2-3" in diameter, on top of the kindling.
7. Light the newspaper in the front. Close and latch the door. Don't leave the fire unattended at
this point. The draft system of the heater should start quickly. It may be necessary to preheat
the chimney to get the draft started. To do this, open the door and add newspaper to the top
backside of the wood. Light or let this paper ignite and allow to burn while holding the door
slightly cracked. Once the draft has started, close and lock the door. You are over heating
the unit if the chimney and or connector glows red.
NOTE: After embers and a coal bed have been established, load the heater with
seasoned natural hard wood, placing it length way front to rear.
NOTE: THE FUELING DOOR MUST REMAIN CLOSED DURING OPERATION.
NOTE: If the optional blower is being used on the Model 261 Non-CatYour stove is
Equipped with a automatic thermostat. When the stove gets hot enough, the
thermostat will activate the room air blower. Set fan speed according to desired
heat output.
NOTE: When refueling or removing ashes turn “OFF” room air blower. Be sure to turn
room air blower back on when finished.
NOTE: Do not run power cord underneath heater or in walk way or heavy traffic areas.
To Next Page
Loading...