Buderus HS 2102 - Troubleshooting; Malfunction display; Burner malfunction

Troubleshooting
Malfunction display
Malfunctions in your heating system are shown in
the display.
The
fo llowing mal fu nc ti ons are reported:
- burner fault
- boil
er temperatu re sensor defective
- out
door te mperature sensor defective
- domestic water sensor defective
- heating remains cold
- domestic water remains cold
- remote control does not react
- internal error.
Have the malfunction repaired immediate ly by a
qualified heating company.
Te ll the heating company on the telephone which
message has been displayed.
Set the sw
it ches as described under the Section
"Emergency operation".
Burner malfun ct io n:
Display: »»BURNER ERR««.
• The heating remains cold.
Clearance:
• Press the burner reset button. The malfunction
message reappears when this attempt was
unsuccessfu
l.
Wh en the burner does not start after several
attempts:
•
Ca ll a heating co mpany!
• Turn
th e switch for boiler ci rc uit emergency
operation on the control panel to "Hand".
BURI~ER
COC I
1.:1'- ''
27