BFC remote control
General
Th
e remote control has various functions. These
have been set accord
in
g to the setting instruc-
tions by your install
in
g contractor during the
insta
ll
ation.
• For the room temperature sensor to function
co
rrectly, all the room temperature sensors
in
the ro
om
in which the remote control
or
the
external room temperature sensor is installed
must be kept fully open at a
ll
tim
es.
Normal heating operation
Setting the daytime room temperature
~
(equivalent to normal heating operation)
•
Set
slide
switch~
to the desired daytime
room temperatur
e,
e.g.
21
°
C.
• The room temperature sensor automatically
corrects malfunctions caused by other heat
sources such as lamps, television, solar
radiation or opened doors and window
s.
The room temperature sensor (in the remote
control or external) transmits variations
in
temperat
ur
e to the electronic control panel
where they are automatica
ll
y equalised
by
raising or lowering the boiler water tempera-
tur
e.
Reduced heating operation
Setting the night room temperature
«.
(equivale
nt
to reduced heating operation)
•
Set
slide switch
«.
to the desired night room
temperature,
e.g
. 15°C.
S
li
de switch
«.
is used to set the switch-over
temperature (room temperature) for reduced
h
ea
ting operation
(s
etting range from + 1 0 °C to
+ 25°
C).
The heating is switch
ed
off when the room
temperature is higher than the value set.
If the room temperature is lower
th
an
the value
set, the heating operates with a reduced h
ea
ting
curve until the set room temperature is reached.
The heating circuit pump keeps running for out-
door
temperatures under + 1 oc to protect against
fro
st.
Slide switch
Daytime
temperature
Slide switch
Night
temperature
I
25
To Next Page
Loading...
