By default, BLUETOOTH is ON when the HUB is first activated.
To turn BLUETOOTH ON or OFF, turn the ROTARY WHEEL until
BLUETOOTH appears on the display. Press in on the ROTARY WHEEL
to enter the BLUETOOTH section. Turn the ROTARY WHEEL to toggle
between ON and OFF. Press in on the ROTARY WHEEL to confirm your
selection.
BLUETOOTH
To set the HUB into TTL mode, turn the ROTARY WHEEL until TTL appears
on the display. Press in on the ROTARY WHEEL to enter the TTL section.
Turn the ROTARY WHEEL to toggle between TTL and MAN (for manual).
Press in on the ROTARY WHEEL to confirm your selection.
TTL MODE
The HUB will enter HSS mode automatically when your camera is set above
it’s max sync speed.The HUB will also superseed any settings found on
the LINK. For example, if the LINK is set to COLOR MODE but you are now
shooting above your camera’s max sync speed, the HUB will then adjust
the LINK and place it into HSS MODE.
HSS MODE
ABOUT
To access the serial number, current firmware version, and FCC ID within
the HUB interface, first turn on the HUB and use the rotary dial to scroll
to the ‘ABOUT’ section. Then, once ‘ABOUT’ appears on the display,
press in on the rotary dial to enter the section. Finally, scroll using the
rotary dial to view each item.
To Next Page
Loading...