Keep your work area clean and well lit. Cluttered and dark work areas may cause accidents or
injury.
Keep bystanders, children and visitors away while operating the tool. Distractions can cause
you to lose control.
Do not force tool. Use the correct tool for your application. The correct tool will do the job better
and safer at the rate for which it is designed.
Store idle tools out of reach of children and other untrained persons. Tools are dangerous in
the hands of untrained users.
All work areas should be clean and well lit. Accidents are more likely to occur in poorly lit and
cluttered areas.
Keep children, and other distractions at a distance while operating tools.
Use common sense while operating this power tool.
Do not use this tool if you are:
• Feeling tired or are under the influence of alcohol or drugs.
• Wearing loose clothing or jewelry. Keep long hair pulled back and away from moving parts.
• Overreaching or have improper footing. Handling the tool in this way could cause serious injury.
ASSEMBLY
This is a lifting device only. Do not use it for anything other than it’s intended purpose. Load must
be supported by proper rated capacity jack stands under the vehicle before starting inspection or
work. Do not overload. Jack capacity is 2 tons.
Never stand or place your body beneath the load being lifted.
Never attempt to exceed the limits of the floor jack. Applying excessive force to the tool can
overload the jack, decrease the life and increase the wear on the jack.
BEFORE USE
During shipment or handling, air in jack can become trapped in the hydraulic system, causing jack to malfunction.
To release air from the hydraulic system:
1. Turn release valve counter-clockwise with handle no more than two full turns.
2. Remove oil fill plug.
3. Pump jack handle quickly in several full strokes.
4. Repeat above steps as needed. Remember to replace oil fill plug.
FJ2 2 Ton Trolley Floor Jack Assembly & Operating Instructions 3
To Next Page
Loading...