MAINTENANCE
Some chemicals can damage the product. Do not use harsh chemicals such as gasoline,
carbon tetrachloride, paint thinner, etc. to clean this product.
A qualified repair technician must perform any tool service or repair. Service or maintenance
performed by unqualified personnel could result in injury. Use only identical replacement parts. Use
of unauthorized parts or failure to follow maintenance instructions may create a risk of electric shock
or injury.
1. When jack is not in use, lifting arm and pump lever should be in full down position. This will protect
precision, machined surfaces of the ram and the piston from corrosion.
2. Container is filled with 7 fl. oz. Hydraulic jack oil.
3. Keep clean and well lubricated, as well as the outside moving parts such as the lifting arm spindle, wheel
bearings and cross head pin.
4. Should any other parts be required, please refer to the sectional drawings and quote appropriate serial
number of jack when ordering.
5. ADDING OIL: With ram fully lowered and jack on level ground, remove oil fill plug. Add oil if level is more
than ½ ” below hole. Replace cover plate.
6. REPLACING OIL: Oil should be replaced at least once every year. To drain oil, remove cover plate, oil
filter plug and release valve. Do not allow dirt or foreign matter into system.
7. LUBRICATION: Put grease in fitting on base and lubricate lifting arm spindle with oil every 3 months.
8. RUST PREVENTION: With an oily cloth, clean and wipe the piston ram and pump piston every 3 months
or when signs of rust or corrosion appear. When not in use, always leave the saddle and
pump piston in the
down position.
ACCESSORIES
Use only accessories that are recommended by the manufacturer for your model. Accessories that
may be suitable for one tool may become hazardous when used on another tool.
FJ2 2 Ton Trolley Floor Jack Assembly & Operating Instructions 5
To Next Page
Loading...