Buffalo BS-GS20 Series User Manual

Chapter 2 Settings
Refer to the “Open Settings” section in chapter 1 to access Settings.
Menu
System Information Displays the switch’s information.
Basic
System Configure the switch’s name, location, and contact.
VLAN
VLAN Settings
Confirm VLAN status and create new VLAN. This switch’s IP
address can also be configured on this page.
VLAN Ports Configure PVID (Port VLAN ID).
Routing
L2/L3 Settings Switch between L2 mode and L3 mode.
Static Routing
(L3 mode only)
Configure the gateway to access the specific destination.
SNMP
SNMP Community Table Configure SNMP community table.
SNMP Host Table Configure SNMP host table.
SNMP Trap Configure SNMP trap.
SNMPv3 User Configure SNMPv3 user information.
LLDP
LLDP Properties Configure LLDP.
LLDP Port Configure LLDP for each port.
LLDP-MED Port Configure LLDP-MED for each port.
Neighbor Table
Displays the information of LLDP-compatible products
connected to the switch.
MAC Addresses
Static MAC Filtering Configure static MAC address-based filtering.
Dynamic MAC Filtering Configure dynamic MAC address-based filtering.
Convert MAC Address
Add dynamic MAC addresses to the static MAC address table to
filter them in static MAC filtering.
Static MAC Address Register static MAC addresses to the MAC address table.
MAC Address Aging Configure MAC address aging time.
Port Settings
Status Displays port status.
Speed/Mode Settings Configure transmission rate and flow control for each port.
System Security
Administration Account Configure administration username and password.
Access Management Configure each administration interface.
Certificate Configure certificate.
Date & Time Configure date and time by using SNTP or manually.
PoE
(PoE-compatible
switches only)
Status Displays PoE status.
PoE Profiles Configure PoE settings.
Power Profiles Configure power saving schedules.
Advanced
13
Chapter 2 Settings

Buffalo BS-GS20 Series Specifications

General

Brand	Buffalo
Model	BS-GS20 Series
Category	Switch
Language	English