What to do if my Buffalo CJ787 is not working?
If your Buffalo Boiler isn't working, first ensure it's correctly plugged in and switched on. Check the plug and lead for any damage, replacing them if necessary. Also, verify the fuse in the plug hasn't blown and replace it if needed. Finally, check the mains power supply to rule out any faults there.
Why are indicator lights on my Buffalo Boiler?
Indicator lights may be on due to several reasons. It could be due to heating elements disconnection, temperature sensor failure, overflow alarm, leakage alarm, or abnormal inlet water. Unplug the appliance and have a qualified Technician check the connection, sensor, upper water level probe and Solenoid valve, heating elements, and other electrical components. Also, check that the water supply is normal and the water inlet hose is not blocked. If the problem persists, consult a qualified Technician.
What to do if my Buffalo CJ787 has auto filling failure?
If your Buffalo Boiler is experiencing auto filling failure, first ensure that the water valve is open. Then, check the water supply and water pressure to make sure they are adequate. If the issue persists, it could be a water level probe failure, and you should consult a qualified Technician.
What to do if no water is dispensed and is flashing on my Buffalo CJ787?
If no water is being dispensed and the unit is flashing, it indicates a water shortage. Check that the water supply is normal and the water inlet hose is not blocked. If the problem persists, consult a qualified Technician.
To Next Page
General
