7
5. Do not put the equipment in an area where the equipment’s flue may be obstructed. Also, do
not directly connect the equipment’s flue to any ventilation equipment or system.
6. Any gas burning appliance requires adequate clearance and ventilation for optimum and trouble-
free operation. The minimum installation clearances shown are to be adhered to.
Clearances
NOTE: THESE UNITS ARE SUITABLE FOR INSTALLATION ON NON-COMBUSTIBLE
SURFACES ONLY.
For use in non-combustible locations only
For use only on non-combustible countertops
Noncombustible and unit clearances: sides and rear – 10”(250mm) floor
NOTE: This Gas Char-Grill is supplied with adjustable stand/feet to enable the appliance to be
positioned securely and level. The installation of the gas stand should be carried out
before the completion of the gas connection.
D. Install the gas stand
1. Remove the feet from the packaging
2. For initial installation, remove radiant and cast grate, upturn and support your gas equipment,
taking care as items may be heavy. Screw the feet into the gas equipment.
3. Locate the equipment into its final operating position. Then, using a sprit level, adjust the feet
to the correct level and height. Then, install the flue and all the cast radiants and cast grates.
To Next Page
Loading...
