stap 7 fitting the frame on the chassis
a. Fit the frame supports on the frame bearers.
b Press the frame downwards until you hear a ‘click’ on
both sides. The frame is now attached to the chassis.
WARNINGS
• Check that the frame is attached to the chassis. Pick up the frame. If the frame
releases one or both sides of the chassis, press the frame onto the chassis again
until you hear a ‘click’ on both sides.
other functions
placing the frame in different positions
a. Place the frame on the chassis.
b. Squeeze together the squeeze-fastener on the centre axle.
c Tilt the frame by lifting the top part.
Put the frame in one of the 3 positions.
Note Just the seat can be put in 3 frame positions.
The carrycot can only be used horizontally.
To Next Page
Loading...
