What to do if my Buhler Accessories has no display?
If your Buhler Accessories unit's display is not working, the issue could be due to a lack of power. Check the power supply to ensure it is properly connected and functioning. Alternatively, a blown fuse might be the cause. Inspect the fuse and replace it if necessary.
What to do if there is condensate in the gas outlet of my Buhler PKE 511?
If you notice condensate in the gas outlet of your Buhler Accessories, it could be due to several reasons. First, the condensate vessel might be full, so try draining the vessel. Another possibility is that the valve in the automatic condensate drain is stuck; in this case, flush it in both directions. Finally, the cooler may be overloaded, so check the limiting parameters.
Why is the status LED blinking with a high temperature on my Buhler Accessories?
The status LED on your Buhler Accessories might be blinking due to high temperature for several reasons. The operational temperature might not have been reached yet; wait for a maximum of 20 minutes. The cooling capacity might be too low, so ensure free air circulation and that ventilation louvres are not obstructed. High gas flow, dew point, or gas temperature could also be the cause; check application parameters and consider installing a pre-separator. Lastly, the fan might be broken; inspect the fan and replace it if needed.
How to troubleshoot reduced gas flow in Buhler Accessories?
If you're experiencing reduced gas flow in your Buhler Accessories, it could be due to a clogged gas path. Check and flush the heat exchanger. Alternatively, the condensate outlet might be clogged by ice, in which case you should send the cooler for inspection.
What to do if the status LED blinks with a low temperature on my Buhler PKE 511?
If the status LED on your Buhler Accessories is blinking due to a low temperature, the controller may be defective. Send the cooler for inspection.
What to do if my Buhler PKE 511 displays error 02?
If your Buhler Accessories displays error code 02, it indicates a short circuit. This means that there is a temperature sensor defect. Send the cooler for repair.
What to do if my Buhler PKE 511 Accessories displays error 01?
If your Buhler Accessories unit displays error code 01, it indicates a broken wire, meaning there is a temperature sensor defect. Send the cooler for repair.
General| Brand | Buhler |
|---|---|
| Model | PKE 511 |
| Category | Accessories |
| Language | English |
To Next Page