Sample Gas Cooler PKE 5
Accurate measurement of gases requires gas samples with
stable dew points even under harsh ambient conditions.
The PKE 5 is designed for moderate ambient and gas
temperatures (2.5 lpm at @ 158 °F) and an inlet dew point of
about 104 °F (approx. 5% vol). For higher ambient tempera-
tures up to a maximum of 122 °F order the PKE 52x.
The dew point of 41 °F is regulated by an electronic control-
ler. The temperature (in °F or °C) of the cooling block is
shown on an LED-display. The status is indicated by a
flashing display which shows high or low temperature and
operates together with a relay in fail-safe mode.
Condensate is removed by peristaltic pumps, automatic
condensate drains or condensate vessels.
The PKE Models feature a semiconductor Peltier cooling
system with an aluminum cooling block. Fitted into the block
is a removable high-efficiency heat exchanger made of
stainless steel, DURAN-glass or PVDF.
§
§
§
§
§
§
§
§
§
§
Compact design
Easy installation
No maintenance required
Low noise
Efficient heat exchangers made of
stainless steel, Duran glass or PVDF
Nominal cooling capacity 85/95 Btu/hr
Dew point stability 0.2 °F
Status display and output
Cooling temperature display
Model available for high ambient
temperatures
DA 44 0012
Page 1/4
10/2013
Buhler Technologies LLC
1030 West Hamlin Road, Rochester Hills, MI 48309
Phone: 248.652.1546 Fax: 248.652.1598
Internet: www.buhlertech.com
e-mail: sales@buhlertech.com
To Next Page
Loading...