Memory Seat and Mirrors
This is another Personal Choice feature of your Riviera.
The transmitters can
also
be
programmed to move
the
driver’s seat and outside
mirrors
to a set
memory
position
when the key chain transmitter’s UNLOCK button
is
pressed.
To
program the system:
1.
Adjust the driver’s seat to a comfortable position.
Adjust both outside mirrors to suit you. See “Power
Remote Control Mirror” in the Index.
2.
Press the SET button on the driver’s door armrest.
You will hear one beep.
3.
Within five seconds, press one of the two memory
buttons on the armrest. You will hear two beeps to
confirm that the mirror and the seat positions are
entered into memory.
4.
Press the UNLOCK button on the appropriate
transmitter within five seconds. You will hear
two beeps.
The second key chain transmitter can be programmed to
record a different seat and mirror position by following
the same steps.
If
you prefer to program the exit seat position, which
moves the seat completely down and back, follow
these steps:
1.
Press the
SEiT
button on the driver’s door armrest.
You will hear one beep.
2.
Press the EXIT button on the armrest. You will hear
one beep, but the seat will not move at this time.
3.
Press the UNLOCK button on the appropriate
transmitter within five seconds.
You
will hear
two beeps.
This personal choice feature will work only when the
vehicle is
in
PARK (P). A beep
will
sound inside the
vehicle when the UNLOCK button on the transmitter
is
pressed to move the seat and mirrors.
To
turn
this feature off, press SET and then
UNLOCK
within five seconds.
2-11
To Next Page
Loading...
