Turn Signal/Multifunction Lever
The lever on the left side of the steering column
includes the following:
• G Turn and Lane-Change Signals. See Turn and
Lane-Change Signals on page 3-7.
• 53Headlamp High/Low-Beam Changer. See
Headlamp High/Low-Beam Changer on page 3-8.
• Flash-to-Pass. See Flash-to-Pass on page 3-8.
• WIPER N Windshield Wipers. See Windshield
Wipers on page 3-9.
• L PUSH Windshield Washer. See Windshield
Washer on page 3-9.
• CRUISE I Cruise Control. See Cruise Control
on page 3-10.
Turn and Lane-Change Signals
The turn signal has two upward (for right) and
two downward (for left) positions. These positions
allow you to signal a turn or a lane change.
To signal a turn, move the lever all the way up or
down. When the turn is finished, the lever will return
automatically.
An arrow on the instrument
panel cluster and the HUD
display will flash in the
direction of the turn or
lane change.
To signal a lane change, just raise or lower the lever
until the arrow starts to flash. Hold it there until you
complete your lane change. The lever will return by
itself when you release it.
As you signal a turn or a lane change, if the arrow
flashes faster than normal, a signal bulb may be burned
out and other drivers will not see your turn signal.
3-7
To Next Page
Loading...
