Interior Lighting Delay
The interior lighting delay feature can be programmed to
one of the following modes:
OFF: This feature will not illuminate the interior of your
vehicle when all of the doors are closed.
ON: This feature will continue to illuminate the interior
lamps for 25 seconds after all doors have been
closed so that you can find your ignition and buckle
your safety belt at night.
Interior lighting delay will not occur while the ignition is
in ON. After 25 seconds, the interior lamps will fade
out. The lamps will fade out before the 25 seconds if
one of the following occurs:
• The ignition is turned to ON
• All doors are locked using the remote keyless entry
transmitter
• There is no occupant activity detected for an
illumination period of 25 seconds
Your vehicle was originally programmed to ON. The
mode may have been changed since then. To determine
the current mode, or to change the mode, do the
following:
1. Follow the instructions for “Entering Programming
Mode” listed previously.
2. Press the MODE button until INTERIOR LIGHTING
DELAY appears on the DIC.
3. Press the SET button until the arrow is before
ON or OFF.
The mode you selected is now set. You can either
exit programming mode by following the instructions
later in this section or program the next feature available
on your vehicle.
3-66
To Next Page
Loading...
Need help?
General
