Securing a Child Restraint Designed for
the LATCH System
{CAUTION:
If a LATCH-type child restraint is not attached
to anchors, the restraint will not be able to
protect the child correctly. In a crash, the child
could be seriously injured or killed. Make sure
that a LATCH-type child restraint is properly
installed using the anchors, or use the
vehicle’s safety belts to secure the restraint,
following the instructions that came with that
restraint, and also the instructions in this
manual.
{CAUTION:
Each top tether anchor and lower anchor in
the vehicle is designed to hold only one child
restraint. Attaching more than one child
restraint to a single anchor could cause the
anchor or attachment to come loose or even
break during a crash. A child or others could
be injured if this happens. To help prevent
injury to people and damage to your vehicle,
attach only one child restraint per anchor.
1. Find the lower anchors, if equipped, for the desired
seating position.
2. If the desired seating position does not have lower
anchors or the child restraint does not have lower
anchorages, see Securing a Child Restraint in
a Rear Outside Seat Position on page 1-65,
Securing a Child Restraint in the Center Rear Seat
Position on page 1-67, and Securing a Child
Restraint in the Right Front Seat Position on
page 1-69 for instructions on installing the child
restraint using the safety belts.
3. Put the child restraint on the seat.
1-63
To Next Page
Loading...
Need help?
General
