Keys, Doors, and Windows 35
Canceling a Remote Start
To cancel a remote start, do any of
the following:
.
Press and hold
/ until the
parking lamps turn off.
.
Turn on the hazard warning
flashers.
.
Turn the vehicle on and then off.
Conditions in Which Remote Start
Will Not Work
The remote start will not operate if:
.
The key is in the ignition (Key
Access) or the ignition is in any
position other than OFF (Keyless
Access).
.
The transmitter is in the vehicle
(Keyless Access).
.
The hood is not closed.
.
The hazard warning flashers
are on.
.
There is an emission control
system malfunction.
.
The engine coolant temperature
is too high.
.
The oil pressure is low.
.
Two remote vehicle starts have
already been used.
.
The vehicle is not in P (Park).
Door Locks
{
Warning
Unlocked doors can be
dangerous.
.
Passengers, especially
children, can easily open
the doors and fall out of a
moving vehicle. The chance
of being thrown out of the
vehicle in a crash is
increased if the doors are
not locked. So, all
passengers should wear
safety belts properly and the
doors should be locked
whenever the vehicle is
driven.
.
Young children who get into
unlocked vehicles may be
unable to get out. A child
can be overcome by
(Continued)
Warning (Continued)
extreme heat and can suffer
permanent injuries or even
death from heat stroke.
Always lock the vehicle
whenever leaving it.
.
Outsiders can easily enter
through an unlocked door
when slowing or stopping
the vehicle. Lock the doors
to help prevent this from
happening.
To lock or unlock the doors from the
outside, press
Q or K on the
Remote Keyless Entry (RKE)
transmitter or use the key in the
door. See Remote Keyless Entry
(RKE) System Operation 0 28.
To lock or unlock the doors from the
inside:
.
Press
Q or K on a power door
lock switch.
.
If equipped with Keyless Access,
pushing down the manual lock
knob on the driver door will lock
To Next Page
