To Next PageTo Next Page
Need help?Do you have a question about the Bulldog Security 5002PRO and is the answer not in the manual?
Allows remote lock/unlock of power door locks, even when the engine is running or in valet mode.
System automatically arms 1 minute after the last door is closed. Remotely programmable.
Arms the system and locks doors automatically. Remotely programmable.
Prevents arming when serviced, valet parked, or washed. Allows remote lock/unlock.
Detects voltage reduction from interior dome light, hood, or trunk light.
Doors lock when ignition is turned on and unlock when turned off. Remotely programmable.
Remotely opens your trunk with a single push of a button.
Allows your alarm to learn new remotes, should remotes be added or lost.
Prevents a thief from starting your vehicle even if they have your keys.
Adds protection if the ignition wire is hot-wired or turned on when armed.
DO NOT disconnect the battery if vehicle has anti-theft radio or airbag.
Use a computer-friendly test light or volt/ohm meter for testing wires.
Instructions to locate and identify constant and ignition power wires in the vehicle.
Connects the red wire to 12V supply and black wire to chassis ground. Includes test.
Connects the red/black wire to the ignition power wire. Includes test.
Optional feature: connects starter disable relay to cranking wire. Includes test.
Details connections for optional starter disable relay and harness for specific models.
Secures the starter disable relay and tests its functionality.
Connects the brown wire to the parking lights wire. Includes test.
Connects the black/yellow wire for negative switch or black/blue for positive switch.
Tests the anti-carjacking function and how to return the system to normal operation.
Connects BROWN/BLACK to lock and GREEN/BLACK to unlock for Type A systems.
Connects GREEN/BLACK to lock and BROWN/BLACK to unlock for Type B systems.
Main wiring diagram illustrating connections for system components.
Details the function of each colored wire in the main wiring harness.
Press transmitter button #1 to arm the system; siren chirps once, lights flash.
Press transmitter button #1 again to disarm; siren chirps twice, lights flash.
Press button #2 while armed/disarmed to activate accessory like remote start.
Press and release button #4 to sound panic siren for 30 seconds.
Hold button #4 for 10s to activate; system chirps once. Repeat for deactivation (2 chirps).
Allows system disarming by turning ignition ON and pressing the override switch.
Feature for unsafe neighborhoods to deter carjackers; requires switch activation.
Adjusts sensitivity by striking vehicle within 2s after programming sequence.
Activate valet by disarming, holding button #2 for 10s, then pressing #2 again.
Activate by disarming, holding button #3 for 10s, then pressing #2.
Program new remotes by holding button #1 for 10s and pressing button on new remote.
General| Remote Control | Yes |
|---|---|
| Remote Start | Yes |
| Keyless Entry | Yes |
| Engine Immobilizer | Yes |
| Starter Kill | Yes |
| Door Lock Control | Yes |
| Trunk Release | Yes |
| Anti-Grind Protection | Yes |
| Valet Mode | Yes |
| Parking Light Flash | Yes |
| Alarm Type | 2-Way |
| Shock Sensor | Yes |
| Programmable Features | Yes |
| Hood Pin Switch | Yes |
| Siren | Yes |
| Number of Buttons on Remotes | 5 |
